Rotating die-holder type: "A 10 M/33" |
| The application of a rotating
die-holder is extremely important and advantageous. The die wear is considerably reduced because any change of the ideal axis of the wire to the die is avoided by the rotation. As a matter of fact the die takes advantage from a working surface and not of a stationary point. Using rotating die-holders you can get the following advantages: |
| - highest drawing
performances and yields - better lubrication and wire calibration - longer die-life - higher productivity |
- no tunnelling
phenomena - no wire ovalization - energy saving - better finished wire quality. |
| Technical features: |
| - application - max. inlet diameter (mm) - max. die housing (mm) - type of die cooling - exit wire height (mm) - motor (hp) - die rotation (RPM) - position of the motor - total dimensions (mm) - soap box length (mm) - approx. weight (kg) |
all the passes 8,00 53 cylindrical indirect 67 0,35 6 vertical or horizontal - right or left of the wire path vertical=500 x310 h. 340-horizontal=500 x325 h. 340 220 42
|
|
Attention:
When ordering please specify: A) die-housing dimensions and if cylindrical or cone-shaped.
B) soap box dimensions (if not standard). C) required electrical feature of the motor
(volts-hertz). D) required position of the motor. E) exit wire height (if not standard). |
Rights reserved to modify technical specifications. Dimensions and data are not binding.
Lubrimetal S.p.A. Via
Moggio 19 - 23808 Vercurago (Lecco) ITALY Tel
0039 0341 420 444 Fax 0039 0341 422 386
EMAIL :
info@lubrimetal.com